What have you done to your ride lately?
- Thread starter jdmcq
- Start date
I didn't know there was a mod for it.
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
Go look on TW for a fix. 
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
I went Kayaking last weekend up in north jersey at the Delaware water gap, drove 2+ hours at highway speed and these didn't budge. First real test of the rack, and it worked out pretty well. Got 16 mpg too
You suck.
bakerla
Man, Myth, Legend
I removed mine. The dash light doesn't bother me much.
Replaced the slave cylinder on my 4Runner. After 20 minutes of bleeding it there was still very little pressure and I almost drained the reservoir. Think I will let it sit over night and try again tomorrow. Really hoping something with the clutch master cylinder.
thekidcatcher
Well-Known Member
Is this real life?
I started using mine over there again to try and sell hunts.
I started using mine over there again to try and sell hunts.
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
No.. You are alive and well. It's just a fact, we don't have a lot of 2nd gen fixes over here. But that being said, I'm not going over there.
.
You're gonna get shot by some bro
thekidcatcher
Well-Known Member
probably
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
No.. You are alive and well. It's just a fact, we don't have a lot of 2nd gen fixes over here. But that being said, I'm not going over there.
.
So any thoughts on troubleshooting a clutch master cylinder or just quit being a cheap ass and replace the old thing?
Silverback
Lima Gulf Bravo Foxtrot Juliet Bravo
Just replace it
PSU Taco85
Well-Known Member
I see you put your doors back on
Yeah starting to cool down a bit around here plus it's nice to be able to lock stuff in the truck again haha
You suck.
My gas milage (at least on the highway) went up when I put the 36s on since the highway RPMs are back to stockish. They used to scream with the 285s
Kind of what I was thinking.
I thought I had all the parts I needed to finish fixing my transmission. Turns out that even though the internet was right in saying that the 4wd clutch will fit a 2wd pickup, it failed to mention that you also need a 4wd flywheel...
Anyway, I went ahead and got everything prepped for the arrival of the new flywheel. The old pilot bearing was a bitch to remove. Took a good hour of pounding with the slide hammer to get it out.
Anyway, I went ahead and got everything prepped for the arrival of the new flywheel. The old pilot bearing was a bitch to remove. Took a good hour of pounding with the slide hammer to get it out.
Slide hammer? I used a large syringe from a turkey injector kit to fill the hole with grease and then drove in a small socket to shove it out with hydraulic pressure. Worked like a charm in about ~10 minutes.
That sucks. At least you are closer to running again.